I was reading the F.A.Q section and read the article on shortening the butt of a rod. I have a rod I would like to do this to but was wondering if this will change the action of the rod any?
Thanks,
Eric
Shortening a rod - change action?
-
- Posts: 22
- Joined: Tue Mar 18, 2008 10:21 pm
- Location: Plant City, FL
Shortening a rod - change action?
When you need it and don't have it...you sing a different tune.
Re: Shortening a rod - change action?
Virtually no change. It'll feel different to fish with - especially if your are a two handed caster - just because you shortened it but the action really doesn't change.
Over every mountain there is a path, although it may not be seen from the valley
Re: Shortening a rod - change action?
I have shortened a couple "steelhead" rods by taking about 5" off the butt end. The action is the same, but the balance was off a bit. I got some "crutch ends" from the hardware store and played with the weight by adding a washer or 2. When it felt right, I epoxied the end on. Just use a good cut-off wheel to make the cut.
Yes, I can get 20 feet of Pontoon boat equipment on a 16 foot Pontoon boat....
-
- Posts: 22
- Joined: Tue Mar 18, 2008 10:21 pm
- Location: Plant City, FL
Re: Shortening a rod - change action?
That's good to hear. I hate how it catches my shirt and really didn't want to start into rod builing right now. Although it is on my to do list.
When you need it and don't have it...you sing a different tune.